SolutionIn order to use the NI-VISA drivers and both the Keysight (HP Agilent) and NI GPIB devices, you will need to enable:. NIVISATulip.dll. NI 488.2 from within the Keysight (or Agilent) librariesComplete the steps in the following document to enable NIVISATulip.dll:Complete the following steps to enable NI 488.2, depending on the Connection Expert Version you have.Note: During Version 17.x, the software name changed from Agilent Connection Expert to Keysight Connection Expert.Keysight Connection Expert 17.x steps:1. Under the Settings tab, select OptionsKeysight 488 Options.2. Check Enable Keysight GPIB cards for 488 programs.Agilent Connection Expert 16.x and 15.x steps:1. Select ToolsAgilent 488 from the pulldown menu.2. Select the Agilent 488 Options tab.3.
ADLINK LPCI-3488A GPIB controller interface card, fully compatible with the IEEE 488 instrumentation control and communication standard, is capable of controlling up to 14 stand-alone instruments via IEEE 488 cables. It is designed to meet the requirements for high performance and maximum programming portability. The built-in 2KB FIFO and a block transfer mode provide up to 1.5 MB/s GPIB transfer rate. With the APIs that are compatible with NI-488.2* and VISA support, the LPCI-3488A provides the greatest compatibility with your existing applications and instrument drivers. (* NI-488.2 mentioned herein is the trademarks and properties of National Instruments Corporation.) 153554b96e